Configuring Local Port Mirroring; Local Port Mirroring Configuration Task List; Creating A Local Mirroring Group; Configuring Source Ports For The Local Mirroring Group - HP 5500 EI Series Configuration Manual

disable MAC address learning of the remote probe VLAN. For more information about the mac-address
mac-learning disable command, see Layer 2—LAN Switch Command Reference.

Configuring local port mirroring

Local port mirroring configuration task list

Configure a local mirroring group and then configure one or more source ports and a monitor port for
the local mirroring group.
Complete these tasks to configure local port mirroring:
Task

Creating a local mirroring group

Configuring source ports for the local mirroring group

Configuring the monitor port for the local mirroring group
Using the remote probe VLAN to enable local mirroring to support
multiple monitor ports
Creating a local mirroring group
Step
1. Enter system view.
2. Create a local mirroring
group.
NOTE:
A local mirroring group takes effect only after you configure a monitor port and source ports for it.
Configuring source ports for the local mirroring group
If you use system view, you can use a list to configure multiple source ports for a mirroring group at one
time. If you use interface view, you can assign only the current port to the group as a source port, so you
must repeat the step for each additional port.
Configuration restrictions and guidelines
A port can belong to only one mirroring group.
Configuring source ports in system view
Command
system-view
mirroring-group group-id local
90
Remarks
Required.
Required.
Required.
Optional.
Remarks
N/A
No local mirroring group
exists by default.