Fips Compliance; Information Center Configuration Task List; Outputting System Information To The Console - HP 5500 EI Series Configuration Manual

FIPS compliance

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see Security Configuration Guide.

Information center configuration task list

Task

Outputting system information to the console

Outputting system information to the monitor terminal
Outputting system information to a log host
Outputting system information to the trap buffer
Outputting system information to the log buffer
Outputting system information to the SNMP module
Outputting system information to the Web interface
Managing security logs and the security log file
Enabling synchronous information output
Disabling an interface from generating link up or link down logging information
Outputting system information to the console
Step
1. Enter system view.
2. Enable the information
center.
3. Name the channel with a
specified channel
number.
4. Configure an output
channel for the console.
5. Configure an output rule
for the console.
Command
system-view
info-center enable
info-center channel channel-number
name channel-name
info-center console channel
{ channel-number | channel-name }
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
43
Remarks
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
Optional.
Enabled by default.
Optional.
See Table 2 for default channel names.
Optional.
By default, system information is output
to the console through channel 0
(known as console).
Optional.
See "Default output rules of system
information."