Enabling Cwmp; Configuring Acs Attributes; Configuring The Acs Url - HP 5500 EI Series Configuration Manual

Task
•
Specifying an SSL client policy for HTTPS connection to ACS

Enabling CWMP

CWMP configurations can take effect only after you enable CWMP.
To enable CWMP:
Step
1. Enter system view.
2. Enter CWMP view.
3. Enable CWMP.

Configuring ACS attributes

ACS attributes include ACS URL, username and password. When the CPE initiates a connection to the
ACS, the ACS URL, username and password are carried in the connection request. After the ACS receives
the request, if the parameter values in the request are consistent with those configured locally, the
authentication succeeds, and the connection is allowed to be established. If not, the authentication fails,
and the connection is not allowed to be established.

Configuring the ACS URL

You can assign only one ACS to a CPE and the ACS URL you configured overwrites the old one, if any.
To configure the ACS URL:
Step
1. Enter system view.
Command
system-view
cwmp
cwmp enable
Command
system-view
210
Remarks
Optional.
Remarks
N/A
N/A
Optional.
•
When the device starts up with
empty configuration, the
software initial settings are
used, and CWMP is enabled.
•
When the device starts up with
the default configuration file,
the software default settings are
used, and CWMP is disabled.
For more information about the
initial settings and default
configuration file, see
Fundamentals Configuration
Guide.
Remarks
N/A