Saving Security Logs Into The Security Log File - HP 5500 EI Series Configuration Manual

# Use channel console to output log information to the console. (This step is optional because it is the
default setting.)
[Sysname] info-center console channel console
# To avoid outputting unnecessary information, disable the output of log, trap, and debug information of
all modules on channel console.
[Sysname] info-center source default channel console debug state off log state off trap
state off
# Configure an output rule to output to the console ARP and IP log information that has a severity level
of at least informational. (The source modules that are allowed to output information depend on the
switch model.)
[Sysname] info-center source arp channel console log level informational state on
[Sysname] info-center source ip channel console log level informational state on
[Sysname] quit
# Enable the display of log information on a terminal. (Optional, this function is enabled by default.)
<Sysname> terminal monitor
Info: Current terminal monitor is on.
<Sysname> terminal logging
Info: Current terminal logging is on.
Now, if the ARP and IP modules generate log information, the information center automatically sends the
log information to the console.

Saving security logs into the security log file

Network requirements
Save security logs into the security log file Flash:/securitylog/seclog.log every one hour.
•
Only the security log administrator can view the contents of the security log file. No other users
•
cannot view, copy, or rename the security log file.
Figure 21 Network diagram
System
administrator
Device
Console
1.1.1.1/24
IP network
Security log
administrator
192.168.1.1/24
FTP Server
192.168.1.2/24
57