Udp Jitter Test Configuration Example - HP 5500 EI Series Configuration Manual

NQA entry (admin admin, tag test) history record(s):
Index
1

UDP jitter test configuration example

Network requirements
As shown in
between Device A and Device B.
Figure 45 Network diagram
Configuration procedure
Before you make the configuration, make sure the devices can reach each other.
1. Enable the NQA server, and configure a listening service to listen to IP address 10.2.2.2 and UDP
port 9000 on Device B.
<DeviceB> system-view
[DeviceB] nqa server enable
[DeviceB] nqa server udp-echo 10.2.2.2 9000
2. Configure Device A:
# Create a UDP jitter test group.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type udp-jitter
# Configure UDP jitter packets to use 10.2.2.2 as the destination IP address and port 9000 as the
destination port.
[DeviceA-nqa-admin-test-udp-jitter] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-udp-jitter] destination port 9000
# Configure the device to perform UDP jitter tests at an interval of 1000 milliseconds.
[DeviceA-nqa-admin-test-udp-jitter] frequency 1000
[DeviceA-nqa-admin-test-udp-jitter] quit
# Start UDP jitter tests.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Stop UDP jitter tests after a period of time.
[DeviceA] undo nqa schedule admin test
# Display the result of the last UDP jitter test.
[DeviceA] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Response Status
64 Succeeded
Figure 45, configure NQA UDP jitter tests to test the delay jitter of packet transmission
Time
2011-01-22 10:12:47.9
144