Enabling synchronous information output
The output of system logs interrupts ongoing configuration operations, and you have to find the
previously input commands before the logs. Synchronous information output can show the previous input
after log output and a command prompt in command editing mode, or a [Y/N] string in interaction
mode so you can continue your operation from where you were stopped.
If system information, such as log information, is output before you input any information under the
current command line prompt, the system does not display the command line prompt after the system
information output.
If system information is output when you are inputting some interactive information (non Y/N
confirmation information), the system displays your previous input in a new line but does not display the
command line prompt.
To enable synchronous information output:
Step
1.
Enter system view.
2.
Enable synchronous
information output.
Disabling an interface from generating link up or
link down logging information
By default, all interfaces generate link up or link down log information when the interface state changes.
In some cases, you might want to disable specific interfaces from generating this information. For
example:
You are concerned only about the states of some interfaces. In this case, you can use this function
•
to disable other interfaces from generating link up and link down log information.
An interface is unstable and continuously outputs log information. In this case, you can disable the
•
interface from generating link up and link down log information.
Use the default setting in normal cases to avoid affecting interface status monitoring.
To disable an interface from generating link up or link down logging information:
Step
1.
Enter system view.
2.
Enter interface view.
Command
system-view
info-center synchronous
Command
system-view
interface interface-type
interface-number
52
Remarks
N/A
Disabled by default
Remarks
N/A
N/A