Configuring A Remote Source Group (On The Source Device) - HP 5500 EI Series Configuration Manual

Configuring the remote probe VLAN for the remote destination group
1. Configuration restrictions and guidelines:
A VLAN can serve for only one mirroring group.
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively. Do not configure a VLAN interface for the VLAN or configure any other
features for the VLAN.
When a VLAN is configured as a remote probe VLAN, you must remove the remote probe
VLAN configuration before deleting the VLAN.
When you remove the configuration of a remote probe VLAN, an active mirroring group
becomes inactive.
2. Configuration procedure:
Step
1. Enter system view.
2. Configure the
remote probe
VLAN.
Assigning the monitor port to the remote probe VLAN
Step
1. Enter system view.
2. Enter the interface view of the
monitor port.
3. Assign the port to the probe VLAN.
For more information about the port access vlan, port trunk permit vlan, and port hybrid vlan commands,
see Layer 2—LAN Switching Command Reference.

Configuring a remote source group (on the source device)

Creating a remote source group
Step
1. Enter system view.
Command
system-view
mirroring-group group-id
remote-probe vlan rprobe-vlan-id
Command
system-view
interface interface-type interface-number
•
For an access port:
port access vlan vlan-id
•
For a trunk port:
port trunk permit vlan vlan-id
•
For a hybrid port:
port hybrid vlan vlan-id { tagged |
untagged }
Command
system-view
96
Remarks
N/A
By default, no remote probe VLAN is
configured for a remote destination group.
Remarks
N/A
Remarks
N/A
N/A
Use one of the
commands.