Configuring The Cwmp Connection Interface; Sending Inform Messages - HP 5500 EI Series Configuration Manual

Step
2. Enter CWMP view.
3. Configure the CPE username
for connection to the CPE.
4. Configure the CPE password
for connection to the CPE.

Configuring the CWMP connection interface

The CWMP connection interface is the interface that the CPE uses to communicate with the ACS. The CPE
sends the IP address of this interface in the Inform messages and the ACS replies to this IP address for
setting up a CWMP connection.
If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address on
the device, you do not need to specify the CWMP connection interface. If multiple Layer 3 interfaces are
configured, specify the CWMP connection interface to make sure the IP address of the interface that
connects to the ACS is sent to the ACS for setting up CWMP connection.
To configure a CWMP connection interface:
Step
1. Enter system view.
2. Enter CWMP view.
3. Set the interface that connects
the CPE to the ACS.

Sending Inform messages

You must configure the Inform message sending parameter on the CPE to initiate a connection to the
ACS.
To configure the CPE to periodically send Inform messages:
Step
1. Enter system view.
Command
cwmp
cwmp cpe username username
cwmp cpe password [ cipher |
simple ] password
Command
system-view
cwmp
cwmp cpe connect interface
interface-type interface-number
Command
system-view
212
Remarks
N/A
By default, no CPE username is
configured for connection to the
CPE.
Optional.
You can specify a username
without a password for
authentication, but make sure that
the ACS has the same
authentication setting as the CPE.
By default, no CPE password is
configured for connection to the
CPE.
Remarks
N/A
N/A
By default, the interface for
connecting the CPE to the ACS is
not configured.
Remarks
N/A