Tcp Test Configuration Example - HP 5500 EI Series Configuration Manual

# Display the history of SNMP tests.
[DeviceA] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index
1

TCP test configuration example

Network requirements
As shown in
between Device A and Device B.
Figure 47 Network diagram
Configuration procedure
Before you make the configuration, make sure the devices can reach each other.
1. Enable the NQA server, and configure a listening service to listen to IP address 10.2.2.2 and TCP
port 9000 on Device B.
<DeviceB> system-view
[DeviceB] nqa server enable
[DeviceB] nqa server tcp-connect 10.2.2.2 9000
2. Configure Device A:
# Create a TCP test group.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type tcp
# Configure TCP probe packets to use 10.2.2.2 as the destination IP address and port 9000 as
the destination port.
[DeviceA-nqa-admin-test-tcp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-tcp] destination port 9000
# Enable the saving of history records.
[DeviceA-nqa-admin-test-tcp] history-record enable
[DeviceA-nqa-admin-test-tcp] quit
# Start TCP tests.
[DeviceA] nqa schedule admin test start-time now lifetime forever
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
Response
50
Figure 47, configure NQA TCP tests to test the time for establishing a TCP connection
Status Time
Timeout 2011-01-22 10:24:41.1
148