Configuring The Cpe Working Mode; Specifying An Ssl Client Policy For Https Connection To Acs - HP 5500 EI Series Configuration Manual

• After a connection is established: If there is no packet interaction between the CPE and the ACS
within the configured close-wait timeout, the CPE considers the connection to be invalid and
disconnects the connection.
To configure the close wait timer of a CPE:
Step
Enter system view.
1.
2. Enter CWMP view.
3. Configure the timeout value of
the CPE close-wait timer.

Configuring the CPE working mode

Configure the device to operate in one of the following CPE modes depending on its position in the
network:
Gateway mode—Enables the ACS to manage the device and any CPE attached to the device. Use
•
this mode if the device is the egress to the WAN and has lower-level CPEs.
Device mode—If no CPEs are attached to the device, configure the device to operate in device
•
mode.
Disable CWMP before you change the CPE working mode.
To configure the working mode of the CPE:
Step
1. Enter system view.
2. Enter CWMP view.
3. Configure the working mode
of the CPE.

Specifying an SSL client policy for HTTPS connection to ACS

CWMP uses HTTP or HTTPS for data transmission. If the ACS uses HTTPS for secure access, its URL
begins with https://. You must configure an SSL client policy for the CPE to authenticate the ACS for
establishing an HTTPS connection. For more information about configuring SSL client policies, see
Security Configuration Guide.
To specify an SSL client policy for the CPE to establish an HTTPS connection to the ACS:
Step
1. Enter system view.
Command
system-view
cwmp
cwmp cpe wait timeout seconds
Command
system-view
cwmp
cwmp device-type { device |
gateway }
Command
system-view
214
Remarks
N/A
N/A
Optional.
The default setting is 30 seconds.
Remarks
N/A
N/A
By default, the device operates in
gateway mode.
Remarks
N/A