Occupancy Sensor Setup - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Occupancy Sensor Setup

Lutron occupancy and vacancy sensors work with the GRAFIK Eye
®
when occupancy or vacancy is detected.
Wired occupancy and vacancy sensors may be connected to the contact closure input on the GRAFIK Eye
Sensor Module (QSM), or a Contact Closure Interface in the GRAFIK Eye
CCI Connection
LUTRON
GRAFIK Eye QS
®
control unit
QS Link
LUTRON
GRAFIK Eye QS
®
QSE-IO
control unit
Wireless Radio Powr Savr
sensors must first be associated to one of these devices before they will be recognized by a GRAFIK Eye
section applies to installations where the GRAFIK Eye
RadioRA 2 installation guide for setting up wireless occupancy and vacancy sensors in a RadioRA
®
LUTRON
GRAFIK Eye QS
®
control unit
The following steps are required to program occupancy sensors with a GRAFIK Eye
1. Connect wired sensors, or associate wireless sensors.
2. Choose the mode of operation (scene control or zone control).
3. Select sensors.
4. Assign sensor actions.
5. Configure sensor settings (optional).
®
Wired
Occupancy
Sensor
Wired
Occupancy
Sensor
occupancy and vacancy sensors can be associated with a GRAFIK Eye
TM
Wireless Wireless
Occupancy Sensor Occupancy Sensor
QS Wireless control unit to automatically adjust light levels
®
QS system.
®
QS Link
LUTRON
GRAFIK Eye QS
®
control unit
QS Wireless is being used in a single-room wireless installation. Refer to the
®
QS Link
LUTRON
GRAFIK Eye QS
®
control unit
GRAFIK Eye
®
QS
Sensor Module
Wired
(QSM)
Occupancy Sensor
QS Wireless or QSM. Wireless
®
®
2 system.)
®
QS
Wireless
Sensor Module (QSM)
Occupancy Sensor
QS control unit.
®
QS Control Unit Installation and Operation Guide 25
QS control unit, a QS
®
QS Wireless system. (This
Wireless
Occupancy Sensor