Setting Load Types - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Zone Setup (continued)

Setting Load Types

Fixture load type
Incandescent
MLV (magnetic low-voltage)
ELV (electronic low-voltage)
Hi-Lume /Eco-10
®
0-10 V
Non-dim lighting loads
Neon/Cold cathode
Tu-Wire
®
Advance Mark X
®
DMX
RGB/CMY DMX
Cree LR4/LR6 LED
LED
* Use incandescent load type unless otherwise specified in the LED product selection tool available at www.lutron.com/ledtool.
®
Direct control via
GRAFIK Eye
control unit
LUTRON
Choose this load type from the menu
on the GRAFIK Eye
Incandescent
MLV
—
—
®
—
Non-dim
Neon, CC
Tu-Wire
Tu-Wire
—
—
Cree LR4/LR6 LED
Incandescent*
Control via
QS power module or
®
interface
QS control unit:
®
Power module
Power module
Power module
Fluorescent module
Fluorescent module
Non-dim
Neon, CC
Tu-Wire
Tu-Wire
DMX
RGB/CMY DMX
Fluorescent module
Power module
GRAFIK Eye
®
Load Type Notes
• All electronic low-voltage
(ELV) lighting used with an
interface must be rated for reverse
phase control dimming. Before
installing an ELV light source,
Power
verify with the manufacturer that
module or
their transformer can be dimmed.
interface
When dimming, an ELV interface
(such as the PHPM-PA-DV-WH)
LUTRON
must be used with the control
unit.
• For all DMX or RGB/CMY DMX
lighting, an external DMX interface
(such as the QSE-CI-DMX) must
be used with the control unit.
• Maximum total lighting load for
Lutron
®
Mark X
®
ballasts (120 to 127 V~ only)
must not exceed 6 A per zone
or 16 A per unit.
Zone ratings:
• Not all zones must be connected;
however, connected zones must
have a minimum load:
120 - 127 V~: 25 W
220 - 240 V~: 40 W
• Maximum zone loads:
120 - 127 V~: 800 W
220 - 240 V~: 1200 W
• Maximum total lighting load for
magnetic low-voltage (MLV) varies
by input voltage:
120 - 127 V~: 800 VA / 600 W
220 - 240 V~: 1200 VA / 960 W
QS Control Unit Installation and Operation Guide 17
Tu-Wire and Advance
®
electronic dimming