Associating Multiple Grafik Eye; Control Units - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Associating Multiple GRAFIK Eye

When there is more than one GRAFIK
Eye QS control unit in a system, it is
®
often convenient to associate them so
that certain functions carry over to other
associated GRAFIK Eye
®
units.
• Wired units: When first wired on the QS
link, all unprogrammed GRAFIK Eye
wired control units will replicate scene
activations and Master button presses by
other control units on the link. Associating
or disassociating control units determines
which units on the QS link will "talk"
or "listen" to each other. Control units
associated on a wired QS link will also
replicate timeclock and contact closure
settings.
• Wireless units: GRAFIK Eye
Wireless control units will not
automatically replicate scene activations
or Master button presses, and must
be programmed to do so. (Associating
two wireless control units will not pass
timeclock and contact closure settings
to each other.) When associating multiple
wireless control units, make sure the
wireless mode of both units is set to
"Enabled."
Note: The wireless signal has a range
of 30 ft (9 m) through standard
construction or 60 ft (18 m) line
of sight.
®
QS Control Units
®
To associate two GRAFIK Eye

control units:

1. Begin with the GRAFIK Eye
unit that will "talk" (button presses will
QS control
be replicated on the other control unit; in
the drawing below this is GRAFIK Eye
QS control unit A). Press and hold the top
and bottom scene buttons until the LEDs
QS
®
flash (about 3 seconds).
2. Continue with the GRAFIK Eye
control unit that will "listen" (replicate
button presses on the other control unit;
in the drawing below this is GRAFIK Eye
QS control unit B). Press and hold the top
scene button until the LEDs flash (about
3 seconds).
3. Return to the GRAFIK Eye
unit that will "talk" (A). Press and hold the
QS
®
top and bottom scene buttons until the
LEDs stop flashing (about 3 seconds).
4. Repeating the process in reverse allows
GRAFIK Eye
"listen" to GRAFIK Eye
B, so that both units will follow each
other.
To disassociate two GRAFIK Eye
control units:
Simply repeat the association steps,
in the same order; press and hold
the bottom scene button on B to
disassociate.
QS
®
QS control
®
®
QS
®
QS control
®
QS control unit A to also
®
QS control unit
®
QS
®
GRAFIK Eye QS Control Unit Installation and Operation Guide 51
®
OK
On the unit that will "talk," press
and hold the top and bottom
scene buttons for 3 seconds
to begin or end association or
disassociation with the unit that
will "listen."
®
OK
Associate
OR
Disassociate
On the unit that will "listen," press and hold the
top scene button for 3 seconds to associate,
or press and hold the bottom scene button for
3 seconds to disassociate with the unit that will
"talk."
OK
GRAFIK Eye QS
®
control unit A
"Talks" to GRAFIK
Eye QS control unit
®
B; scene activation
and Master button
presses activated
on control unit A are
replicated on control
unit B.
OK
GRAFIK Eye QS
®
control unit B
"Listens" to GRAFIK
Eye QS control
®
unit A; control
unit B replicates
scene activations
and Master button
presses on control
unit A.