Assigning Sensors; Calibrating Sensors - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Daylight Sensor Setup (continued)
This step allows you to assign sensors to zones on the GRAFIK Eye
Each zone can be assigned to only one sensor, but sensors can be assigned to more
than one zone.

Assigning Sensors

Daylight Sensor
1. If not already done, associate daylight sensors.
Setup
2. Use the Master buttons to highlight "Setup" and press the
"OK" button to accept. Available sensors will be displayed.
Calibrate
3. Use the Master buttons to scroll through the sensors until the
one you wish to assign or unassign is highlighted, and press the
"OK" button to select it.
4. Use the zone raise and lower buttons for the desired zones to
Saved
Searching
assign or unassign the sensor to those zones. The zone raise
button assigns the displayed sensor, and the zone lower button
unassigns it. Press the Timeclock (back) button to return to the
list of available sensors. Repeat for additional sensors.
Sensor x/y
Calibrating the Sensors
xxxx-xxxx
1. Put any wireless Radio Powr Savr
with the desired zones into "Calibrate Mode": Press and hold
RF
the "Cal." button for 6 seconds until the sensor flashes.
Note: After 5 minutes, "Calibrate Mode" will timeout, and the
Sensor
2. Press the Timeclock (back) button to return to the Daylight
Sensor screen. Use the Master buttons to highlight "Calibrate"
Set Zones
and press the "OK" button to accept.
3. Use the Master buttons to select the desired zone and press the
"OK" button to accept.
4. Use the Master buttons to select the desired light level for the
zone, and press the "OK" button to accept. Repeat for all zone
levels you wish to calibrate.
5. Exit programming mode.
Note: If wireless sensors are not found, verify that they are
Daylight Sensor
Setup
3 seconds
Calibrate
®
sensor will return to normal mode.
associated correctly.
Sensor Name Adjust Light
More light
Zone 1
Less light
QS control unit.
®
daylight sensors associated
TM
Saved
Saved
GRAFIK Eye QS Control Unit Installation and Operation Guide 34
®
Master
buttons
OK
"OK"
button
Timeclock
(back) button
Zone raise: Press to
assign the displayed
sensor
Zone lower: Press to
unassign the desired
sensor
"Cal."
Radio Powr Savr
TM
button
Daylight Sensor