Wireless Control Unit - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Pico Wireless Control Setup (continued)
®
Associating the Pico wireless control with a GRAFIK Eye
®
(for wireless enabled GRAFIK Eye
1. Make sure the wireless mode of the GRAFIK Eye
Pico
"Enabled."
Change type?
2. On the Pico
(off) buttons for 3 seconds. The info screen on the GRAFIK Eye
Press OK
control unit will display the Pico
"OK" button on the GRAFIK Eye
operation type for the Pico
Change type?
3. To assign the Pico
Master buttons to select "Zone" and press the "OK" button to accept.
Zone
3a. Use the zone raise/lower buttons for a zone to select a desired preset
level, and then press the zone raise and lower buttons simultaneously
for 1 second (until the zone LEDs flash at the programmed preset level).
OR
Repeat for all zones you wish to control with the Pico
Change type?
3b. To program other Pico
Raise/Lower), press the desired button and repeat step 3a.
Scene
OR
4. To assign the Pico
Master buttons to select "Scene" and press the "OK" button to accept.
Button Setup
Use the Master buttons to select the desired starting scene for the
First Scene
1
Pico
hold the top scene button on the GRAFIK Eye
Scenes 1–2, off
seconds (until the scene LEDs flash).
5. On the Pico
buttons for 3 seconds until the LEDs on the GRAFIK Eye
unit stop flashing.
Saved
Saved
Note: The wireless signal has a range of 30 ft (9 m) through standard
®
QS control units only)
®
wireless control, press and hold the top (on) and bottom
®
wireless control.
®
wireless control as a zone controller, use the
®
wireless control buttons (not including
®
wireless control as a scene controller, use the
®
wireless control and press the "OK" button to accept. Press and
®
wireless control, press and hold the top and bottom
®
construction or 60 ft (18 m) line of sight.
QS Wireless control unit:
®
QS control unit is
®
wireless control options. Press the
®
QS control unit to select the desired
®
wireless control.
®
QS control unit for 3
®
®
GRAFIK Eye QS Control Unit Installation and Operation Guide 37
®
OK
QS
®
QS control
Pico
®
Wireless
Control
Master
buttons
"OK"
button
Press and
hold the
top scene
button for
3 seconds
to assign
Pico as
®
a scene
controller.
Zone LEDs
Zone Raise
Zone Lower
Top/On
button
Bottom/Off
button