Adjusting Shade Settings; Setting Limits - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Adjusting Shade Settings

Setting Limits

(for wired shades/drapes only)
Note: Entering "Limit Setup" mode
may cause shades to move
approximately 8 in (200 mm) up or
down. Be sure that each shade
is positioned so that the fabric
can safely move 8 in (200 mm) up
or down before entering "Limit
Setup" mode.
1. On any shade button group, press and
hold simultaneously the top and raise
buttons. The LEDs next to the top and
bottom buttons will cycle.
At any time while in "Limit Setup" mode,
you can move all shades together to their
current open limit by double-tapping the
top button, or to their current close limit
by double-tapping the bottom button.
Note: Shade/drape electronic drive units
(EDUs) must first be associated to
a shade button group before its
limits can be adjusted.
®
(for Wired and Wireless Sivoia
2. Select the EDU you want to adjust using
the top button on the shade button
group. Each time you press and release
the top button, a different EDU that is
assigned to that shade button group will
open and close in an 8 in (200 mm) range
to indicate it is selected.
Tap the top button until the EDU for the
shade you wish to adjust moves. (You
can also use the bottom button, which
moves through the assigned EDUs in the
opposite order.)
3. Adjust the currently selected EDU to
the desired level for the open limit (the
maximum the shade is allowed to open)
using the raise and lower buttons.
4. Press and hold the top button on the
shade button group for 5 seconds to
store the current position as the open
limit. The LED next to the top button will
flash quickly for 2 seconds.
5. Adjust the currently selected EDU to
the desired level for the close limit (the
maximum the shade is allowed to close)
using the raise and lower buttons.
6. Press and hold the bottom button on
the shade button group for 5 seconds
to store the current position as the close
limit. The LED next to the bottom button
will flash quickly for 2 seconds.
QS Shades/Drapes)
®
7. Repeat steps 2 through 6 to set the open
and close limits for each shade assigned
to the shade button group.
8. Press and hold simultaneously the top
and raise buttons on the shade button
group to exit "Limit Setup" mode.
Note: Remote limits cannot be set for
GRAFIK Eye QS Control Unit Installation and Operation Guide 45
®
Sivoia QS wireless shades through
®
the GRAFIK Eye QS control unit.
®
Limits must be set manually at
the wireless shade EDU. (See
the Sivoia QS wireless shade
®
instructions.).