Setting High End Or Low End Trim; Setting Minimum Level (Optional) - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Zone Setup (continued)

Setting High End or Low End Trim

• If you are unsure about appropriate high and low end settings,
please contact LutronR Technical Support for assistance.
• High and low end trim settings limit the maximum and minimum
output of a dimming zone. Trim levels are set automatically when
the load type is programmed.
1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight "Zone
CCI Setup
setup" and press the "OK" button to
Zone setup accept.
3. Use the Master buttons to highlight "High
end" or "Low end" (this example shows
low end). Press the "OK" button to accept.
Zone setup
4. Use the zone raise/lower buttons to set
High end
the high end or low end trim for that
Low end
zone. The info screen will display each
zone number and percentage as you
adjust it. Press the "OK" button to accept.
5. The info screen will confirm that your
Low end
setting has been saved.
Set zones
6. Exit programming mode.
Zone 2
10%
Saved
®
1

Setting Minimum Level (optional)

Some local regulations specify a minimum lighting level for
dimming zones in occupied buildings. If this pertains to you,
follow these steps to set up your minimum lighting level.
1. Enter programming mode and select
Zone setup
"Zone setup," then "Min level." Press the
"OK" button to accept.
Low end
2. Use the Master buttons to highlight "Off"
Min level
if you want your lights to go all the way
off at their minimum light level, or "10%"
if you want that to be the minimum light
Min level
level. Press the "OK" button to accept.
Note: Non-dim loads will turn off
Off
3. The info screen will confirm that your
minimum level has been saved.
4. Exit programming mode.
Saved
GRAFIK Eye QS Control Unit Installation and Operation Guide 18
®
OK
2 3 4 5 6
regardless of the minimum level
setting.
Master
buttons
"OK"
button
Use the
zone
raise/lower
buttons to
set the high
end or low
end trim for
that zone.