Table of Contents
Advertisement
Set Low or High End
STEP 16: Set Low or High End
Note: Low End and High End light levels are set automatically when
load type is assigned. This step is to be done if the default settings
need to be changed.
Warning! Do not reduce the Low End or increase the
High End on a Fluorescent Load Type. This will decrease
lamp life and may damage the ballasts.
Warning! Do not increase the High End, of Neon/Cold
Cathode. This may overdrive the lamps and cause
decreased tube life.
To change the setting:
A. Press and hold buttons 1 and 5 until the SELECT VALUE LED
lights.
B. Press button 5 repeatedly until the Low End Trim LED or the
High End Trim LED lights.
C. Use buttons 1 and 2 to go to the circuit that needs to be
changed.
D. Use buttons 3 and 4 to reset the trim as desired. The load will go
to the new setting while in this mode despite the GRX control's
intensity.
Notes:
Low End and High End ranges are limited to avoid
overlapping.
'1' is the minimum Low End and '99' is the maximum High
End.
'Value' is a relative number. It is not a % intensity, but
rather a reference point to help set other circuits, if desired.
Record the new trim setting on a Circuit Directory so that it is
documented.
E. Use buttons 1 and 2 to go to another circuit that needs to be
changed and repeat Step D.
F. Press and hold buttons 1 and 5 until the VIEW VALUE LED
lights.
Note: The Circuit Selector's display will go out automatically 20
minutes after the last button press.
(optional)
Link Link
A B
1 2 3 4
5
C
D
S
C
ELECT
IRCUIT
Circuit
V
V
ALUE
IEW
S
V
ELECT
ALUE
Link A
Link B
Value
S
V
D
ELECT
ALUE
ISPLAYED
Circuit Level
(See Instructions)
Load Type
w/ Circuit Schedule
Zone Assignment
w/ Zone Capture
Zone Assignment
Low-End Trim
High-End Trim
('Ad' Displayed)
Address
Link Link
A B
1 2 3 4
5
C
D
S
C
ELECT
IRCUIT
Circuit
V
V
IEW
ALUE
S
V
ELECT
ALUE
Link A
Link B
Value
S
V
D
ELECT
ALUE
ISPLAYED
Circuit Level
Load Type
(See Instructions)
w/ Circuit Schedule
Zone Assignment
w/ Zone Capture
Zone Assignment
Low-End Trim
High-End Trim
('Ad' Displayed)
Address
Step by Step Instructions for GRAFIK Eye Dimming Panel
D
1
2
A,F
3
4
5
B
TM
D
1
C,E
2
3
D
4
5
TM
19
Advertisement
Table of Contents
