Konica Minolta BIZHUB 501 Service Manual page 586

Field Service Ver.1.0 May. 2008
[4]
[3]
[2] [1]
16aaf2c013na
9.
Remove the separation rubber [2] from the sepa-
ration roller [1].
Note
• Be sure to install the separation rubber [2] so
that the paint mark [3] comes in the opposite
direction of the projection [4].
• When setting the separation rubber, apply
alcohol on the inside of the separation rubber.
By doing so, the separation rubber can be set
more easily.
10.
Reinstall the above parts following the removal
steps in reverse.
2. PERIODIC CHECK
11