To Remove Analog Motherboard - Agilent Technologies 89410A Service Manual

Replacing Assemblies

To remove analog motherboard

To remove analog motherboard
1
Using a T-15 torx driver, remove the screw from the back of
the bottom cover. Slide the cover off.
3
Disconnect the coaxial cables from the assemblies.
3-18
2
Using a T-15 torx driver, remove the screw from the back of
the top cover. Slide the cover off.
4
Using a 5 mm nut driver, remove the screws holding the
assemblies in the card nest. Remove all the assemblies
from the card nest.