Agilent Technologies 89410A Service Manual page 49

e
If this voltage is incorrect then the A82 assembly is probably
faulty.
f
Check the input and output signals of the inverter board as listed
below.
Test Point
CN 1 pin 1
CN 1 pin 2
CN 1 pin 6
CN 2 A
CN 2 B
g If the inputs to the inverter are incorrect the cable is probably
faulty.
h
If the outputs of the inverter are incorrect then the inverter is
probably faulty.
i If the outputs of the inverter are correct then the back light is
probably faulty.
Troubleshooting the Analyzer
To troubleshoot display failures
Signal or Voltage
+ 4.9 Vdc
+ 4.9 Vdc
+ 1.2 Vdc
− 400 V to + 400 V sinewave @ 38kHz (see figure)
− 2.15 V to + 4 V sinewave @ 38 kHz (see figure)
1-31