Maintaining Static Route - Zte ZXR10 5900E Series Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv4 Routing)
View forwarding table on S1:
ZXR10(config)#show ip forwarding route
IPv4 Routing Table:
Dest
10.10.10.0/24
10.10.10.1/32
20.20.20.0/24
30.2.0.0/16
224.0.0.0/4
224.0.0.0/24
255.255.255.255/32 255.255.255.255 NULL
Configuring FRR function of static routes.
To configure FRR function of static route on ZXR10 5900E, use the following command.
Command
ZXR10(config)#
<time-interval>]
Descriptions of the parameters used by command are shown below.
Parameter
<vrf-name>
fast-reroute
<time-interval>

1.3 Maintaining Static Route

To maintain static route on ZXR10 5900E, use the following command.
Command
show ip protocol routing [vrf <vrf_name>]
ZXR10#
SJ-20150114102049-003|2015-01-15 (R1.0)
Gw Interface
10.10.10.1 vlan1
10.10.10.1 vlan1
10.10.10.2 vlan1
10.10.10.2 vlan1
224.0.0.0 NULL
224.0.0.0 NULL
ip route-static [vrf <vrf-name>] fast-reroute [wtr
Description
VRF name, range: 1–32 characters.
Enables the FRR function of static routes.
Interval of WTR, range: 0–12, default: 0.
1-4
Owner Pri Metric
direct 0 0
address 0 0
ospf 110 2
static 1 0
multicast 0 0
multicast 0 0
broadcast 254 0
Function
This enables the FRR function of
static routes.
The generation conditions for
the primary and standby routes
of static routes are: the same
destination address route with
different outgoing interfaces,
different administrative distances
or metric values.
Function
This shows routing table of the
router. Vrf_name is the name of
vrf.
ZTE Proprietary and Confidential