Toshiba e-STUDIO350 Service Manual page 247

[L] Thermostat
(1) Take off the exit unit (
(2) Release the harnesses of thermostat from 3
harness clamps.
(3) Remove 2 screws and take off the thermostat
with the whole holder.
(4) Remove 2 screws and take off the thermostat
from the holder.
Notes:
When installing, pay attention to the followings.
1. Make sure to fix the thermostat, and then
harness terminal in order on the holder.
2. Make sure that the fuser roller is pressed
to the pressure roller when adjusting
the gap between the fuser roller and ther-
mostat with the screw A to be 1.5 mm to 1.9
mm.
[M] IH control PC board (IH board)
(M-1) IH board
(1) Take off the IH terminal cover
( Chapters 2.5.1 [L]).
(2) Take off the right rear cover
( Chapter 2.5.1 [P]).
(3) Take off the SYS board with the whole case
( Chapter 2.5.2 [C]).
(4) Remove 3 screws and take off the IH board cover.
November 2003 © TOSHIBA TEC
Chapter 13.7 [F]).
13 - 23
Fig. 13-728
Fig. 13-729
Screw A
Fig. 13-730
Fig. 13-731
e-STUDIO350/450 FUSER UNIT / PAPER EXIT SECTION
13