Disassembly And Replacement - Toshiba e-STUDIO350 Service Manual

9.4 Disassembly and Replacement

[A] Bypass unit
(A-1) Bypass unit
(1) Remove the upper/lower drawer.
(2) Remove 2 screws and take off the right front
hinge cover.
(3) Remove 2 screws and take off the right rear
hinge cover.
9
(4) Remove 2 screws and take off the right lower
cover.
(5) Remove 1 screw and take off the 2 ground
wires.
(6) Disconnect 1 connector and release the
harness from harness clamp.
e-STUDIO350/450 PAPER FEEDING SYSTEM
Right front hinge cover
Fig. 9-401
Screw
Fig. 9-402
Screw
Fig. 9-403
Ground wire
Fig. 9-404
9 - 10
Screw
Right rear hinge cover
Right lower cover
Connector
Screw
November 2003 © TOSHIBA TEC