Toshiba e-STUDIO350 Service Manual page 176

(10) Take off the tray-up motor.
Note:
Match the boss of the gear with the hole of
the cover when installing the motor.
9
[F] Transport clutch (upper/lower)
(1) Take off the rear cover
( Chapter 2.5 1 [H]).
(2) Take off the tray drive unit with its plate
( Chapter 9.4 [E]).
(3) Remove 3 screws, 1 E-ring and take off the
clutch bracket.
Note:
Do not apply pressure the transport clutch in
all directions when installing the clutch
bracket.
After installing it, open the side cover and
check that the transport roller rotates
smoothly.
e-STUDIO350/450 PAPER FEEDING SYSTEM
Fig. 9-463
Fig. 9-464
Clutch
bracket
Bush
Bush
E-ring
Fig. 9-465
9 - 26
Tray-up motor
November 2003 © TOSHIBA TEC