Disassembly And Replacement - Toshiba e-STUDIO350 Service Manual

6.7 Disassembly and Replacement

[A] Original glass
(1) Take off the right upper cover (
2.5.1 [F]).
(2) Remove 2 screws and take off the fixing
bracket.
6
(3) Take off the original glass.
Note:
When installing, fit 2 small protrusions of the
original glass in the groove of the equipment
and fix the original glass with the fixing bracket
by pushing it to the left rear direction.
[B] Lens cover
(1) Take off the original glass (
(2) Remove 6 screws and take off the lens cover.
[C] Automatic original detection sensor
(APS sensor)
(C-1) A4 series
(1) Take off the lens cover (
(2) Disconnect 1 connector from the SLG board.
(3) Release the harnesses from 6 harness clamps.
(4) Remove 1 screw each and take off the APS
sensors (5 pcs.).
e-STUDIO350/450 SCANNER
Chapter
Protrusion
Original glass
Chapter 6.7 [A]).
Chapter 6.7 [B]).
6 - 16
Fig. 6-701
Fig. 6-702
Fig. 6-703
Fig. 6-704A
November 2003 © TOSHIBA TEC