Toshiba e-STUDIO350 Service Manual page 54

[C] KD-1012 (Large Capacity Feeder (LCF))
(1) Turn OFF the power and unplug the power
cable.
2 2
(2) Remove 7 screws and take off the rear cover
of the equipment.
Note:
Disconnect the connectors of the RADF first
when the RADF is installed.
(3) Remove 1 screw and the ground wire, and
then disconnect 2 connectors (3 if the optional
damp heater is installed).
(4) Remove 2 screws and take off 2 fixing brack-
ets on the rear side.
(5) Take off the lower drawer of the equipment.
e-STUDIO350/450 OUTLINE OF THE MACHINE
Fig. 2-613
Fig. 2-614
Fig. 2-615
Fig. 2-616
2 - 38
Connector of optional
damp heater
November 2003 © TOSHIBA TEC