Toshiba e-STUDIO350 Service Manual page 170

[C] Registration sensor, Upper drawer feed sensor
(1) Take off the front cover (
(2) Take off the front right cover (
(3) Take off the right upper cover (
(4) Take off the cleaner unit (
(5) Take off the IH terminal cover (
(6) Take off the right rear cover (
(7) Remove 1 screw and take off the front cover
stay.
(8) Release the latch from the shaft and take off
the jam release knob.
9
(9) Remove 1 screw and take off the terminal
cover.
(10) Remove 1 screw and disconnect the red lead
wire from the terminal cover.
Note:
Make sure that the harness is inserted into
the dent of the terminal cover when installing.
(11) Disconnect 2 connectors.
e-STUDIO350/450 PAPER FEEDING SYSTEM
Chapter 2.5.1 [A]).
Chapter 2.5.1 [B]).
Chapter 2.5.1 [O]).
Chapter 11.6 [A]).
Chapter 2.5.1 [F]).
Chapter 2.5.1 [G]).
Lead wire
9 - 20
Screw
Front cover stay
Fig. 9-440
Latch
Fig. 9-441
Screw
Terminal
cover
Fig. 9-442
Connector
Fig. 9-443
November 2003 © TOSHIBA TEC
Jam
release knob