Toshiba e-STUDIO350 Service Manual page 201
Hide thumbs
Also See for e-STUDIO350:
- Service handbook (764 pages) ,
- Service manual (302 pages) ,
- Operator's manual (162 pages)
Table of Contents
Advertisement
(E-2) Charger wire
* Length: 363 mm (tungsten wire) diameter:
0.06mm (For both transfer and separation)
(1)
Remove the separation supporter.
(2)
Take off each terminal cover on both front and
rear sides.
(3)
Remove the terminals, springs and wires.
Notes:
Be careful of the followings when installing the wire.
1.
Insert the wire securely into the V-grooves
of the front and rear sides.
2.
Do not twist the wire.
3.
Do not touch the wire directly with bare hands.
[F] Exhaust fan / Sub-separation fan
(1)
Open the jam access cover.
(2)
Take off the transfer and separation chargers
(
Chapter 11.6 (E-1)).
(3)
Remove 4 screws and disconnect 1 connec-
tor. Then take off the fan cover.
(4)
Remove 3 screws and 3 washers. Disconnect
1 connector each from the exhaust fan and
sub-separation fan. Then take off the exhaust
fan and sub-separation fan.
Note:
When installing, pay attention to the direction of the
wind from the fan.
November 2003 © TOSHIBA TEC
Fig. 11-616
Terminal
Spring
Spring
Wire
Fig. 11-617
Fig. 11-618
11 - 13
e-STUDIO350/450 DRUM RELATED SECTON
Wire
Fig. 11-619
11
Advertisement
Table of Contents
