Toshiba e-STUDIO350 Service Manual page 200

(D-2) Recovery blade
(1) Remove the cleaning blade
( Chapter 11.6 (D-1)).
(2) Remove the recovery blade.
Notes:
1. When attaching the recovery blade, clean the
surface of the frame first. Be careful not to de-
form the blade.
2. Attach the recovery blade while pushing it to the
step on the surface of the frame.
3. Press the stuck part with your finger to attach
the blade securely.
(D-3) Separation finger
(1) Remove the drum (
(2) Release the 3 separation fingers.
11
Notes:
1. When replacing the separation fingers, make
sure that the drum has been taken off first since
the fingers may scratch the drum surface.
2. When the separation fingers have been re-
placed, check if their pressure movement is
normal by moving them with your fingers.
[E] Transfer / Separation charger
(E-1) Transfer / Separation charger
(1) Open the bypass tray, ADU and jam access
cover.
(2) Release the latches and take off the transfer
and separation chargers.
Note:
When installing the transfer and separation
chargers, make sure not to deform the springs.
e-STUDIO350/450 DRUM RELATED SECTON
Chapter 11.6 [C]).
11 - 12
Fig. 11-613
Fig. 11-614
Fig. 11-615
November 2003 © TOSHIBA TEC