Toshiba e-STUDIO350 Service Manual page 101

No. Message
74 Misfeed in copier
75 Call for service
76 Please try again after
a while
77 Set standard size
November 2003 © TOSHIBA TEC
State of equipment
Paper jam in the equipment
- Displayed when paper jam occurred in the
equipment
Displayed when motor, sensor, switch, etc.
do not work properly
Displayed when the Department Code can
no be keyed in immediately after power-ON.
Displayed when the paper size which is not
acceptable is set (depends on the setting)
5 - 7
Note
Remove the paper in the equipment
according to the messages displayed
on the panel.
Turn OFF the power and solve the
problem, then turn ON the power.
Leave it for a while and key in the
code again
Reset the paper size.
e-STUDIO350/450 CONTROL PANEL
5