Toshiba e-STUDIO350 Service Manual page 178

[H] Drawer feeding unit (upper/lower)
(H-1) Drawer feeding unit
(1) Take off the upper and lower drawers.
(2) Remove 1 screw and take off the drawer feed-
ing unit by sliding it to the front side.
(H-2) Tray-up sensor
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Disconnect the connector and release the
9
latch to take off the tray-up sensor.
(H-3) Empty sensor
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Disconnect the connector and release the
latch to take off the empty sensor.
(H-4) Paper stock sensor
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Pull up the paper stock sensor arm.
(3) Disconnect the connector and release the
latch to take off the paper stock sensor.
(H-5) Separation roller
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Remove 1 screw and take off the separation
roller holder.
e-STUDIO350/450 PAPER FEEDING SYSTEM
Drawer feeding unit
Fig. 9-470
Empty
sensor
Fig. 9-471
Fig. 9-472
Separation
roller holder
Fig. 9-473
9 - 28
Screw
Tray-up sensor
Paper stock sensor
Paper stock
sensor arm
Screw
November 2003 © TOSHIBA TEC