Toshiba e-STUDIO350 Service Manual page 129

[J] Carriage wire / Carriage-2
(1) Take off the carriage-1 (
(2) Install the wire holder jig to each pulley on front
and rear sides, not to loosen the carriage wire.
Note:
Refer to "3.9 Adjustment of Carriages" in the
Service Handbook for the installation direc-
tion of the wire holder jig.
(3) Remove the tension springs on both front and
rear sides.
(4) Remove the carriage wires on both front and
rear sides.
(5) Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in the
figure at right, not to touch the mirror. Then
take off the carriage-2.
[K] Mirrors-2 and -3
(1) Take off the carriage-2 (
Note:
When replacing the mirrors-2 and -3, re-
place the carriage-2 together with mirrors-
2 and -3.
Mirrors-2 and -3 should not be removed.
November 2003 © TOSHIBA TEC
Chapter 6.7 [G]).
Chapter 6.7 [J]).
6 - 21
Fig. 6-719
Tension spring
Fig. 6-720
Fig. 6-721
e-STUDIO350/450 SCANNER
6