Assembly; Checking The Drive Shaft And Flanges; Fitting The Cutting Blade - Partner K650 ACTIVE III Operator's Manual

Checking the drive shaft and flanges

• Check that the threads on
the drive shaft are
undamaged.
• Check that the contact
surfaces of the cutting blade
and flanges are flat, run
correctly on the spindle and
are free from foreign
objects.
Do not use flanges that are
twisted, have damaged
edges, untrue or dirty. Do
not use different size
flanges..

Fitting the cutting blade

Partner cutting blades are
manufactured and approved
for freehand cutting. The
paper labels on each side of
the blade are there to
distribute the pressure from
the flange washer and prevent
the blade from slipping.
The blade is placed between
the inner flange hub (A) and
the flange hub (B). The
flange hub is turned so that it
fits on the axle. The cutting
blade is tightened using the
socket spanner
501 69 17-02.
The shaft can be locked using
a screwdriver, steel pin or the
like. This is slid in as far as
possible. The blade is tighte-
ned clockwise.
Tightening torque for the bolt
holding the blade is:
15-25 Nm (130-215 in.lb).
Blade guard
The blade guard should
always be fitted on the
power cutter.
The guard should be adjusted
so that the rear section is
close to the work piece.
Cutting fragments and sparks
are then collected by the
guard and led away from the
user.
12
– English

ASSEMBLY

A
B