Carburettor - Partner K950 ACTIVE Operator's Manual

Carburettor

Carburettor
Your Partner product has been designed and manufactured to
specifications that reduce harmful emissions.
After your unit has been run 8-10 tanks of fuel the engine has
broken in. To ensure that your unit is at peak performance and
producing the least amount of harmful emissions after break in,
have your authorized servicing dealer, who has a revolution
counter at his disposal, to check your carburettor for optimum
operating conditions.
Functioning, Final setting
!
WARNING! Do not start the power cutter
without the cutting arm or cutting head fitted.
Otherwise the clutch can come loose and
cause personal injury.
Operation
• The carburettor governs the engine speed via the throttle. Air/
fuel are mixed in the carburettor
Jets
The carburettor is equipped with fixed jets to ensure the engine
always receives the correct fuel air mixture.
If the engine lacks power or accelerates poorly do the following:
• Inspect or, if necessary, replace the air filter.
• If this does not help, contact an authorised service workshop.
Final setting of the idling speed T
Adjust the idling speed with the screw T. If it is necessary to re-
adjust, first turn the idle speed adjusting screw T clockwise, until
the blade starts to rotate. Then turn, counter-clockwise until the
blade stops. A correctly adjusted idle speed setting occurs
when the engine runs smoothly in every position. It should also
be good margin to the rpm when the blade starts to rotate.
Recommended idling speed: 2 500 rpm.
!
Contact your servicing dealer, if the idle speed
setting cannot be adjusted so that the blade
stops. Do not use the power cutter until it has
been properly adjusted or repaired.
MAINTENANCE
T
17
English –