Rear Panel - LevelOne WBR-1101TX User Manual

LevelOne WBR-1101TX User Guide

Rear Panel

Printer Port
Serial Port
ISDN Port
ISDN/WAN
Push Button
WAN port
(10BaseT)
DIP switches
PC port
(10/100BaseT)
HUB port
(10/100BaseT)
Figure 2: Rear Panel
Standard parallel printer port. If you wish to share a printer, connect
it here.
RS232 Serial Port. If you have an analog modem or ISDN TA,
connect it here.
Connect this port to the S/T connector on your ISDN NT1 (Network
Terminator 1).
ISDN and WAN ports can NOT be used simultaneously !
This button determines which port - the ISDN port or the WAN port
- is active.
•
Depressed (in) position - ISDN active
•
Extended (out) position - WAN port active
Connect the Broadband Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Refer to the following table.
If connecting directly to your PC (no Hub) use this port and a stan-
dard LAN cable (RJ45 connectors).
Use EITHER the PC port OR the Hub port, NOT both.
Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseT hub.
Use EITHER the PC port OR the Hub port, NOT both.
6