Rear Panel - LevelOne FBR-1800TX User Manual

Rear Panel

Printer Port
Reset Button
10/100BaseT
LAN connections
WAN port
(10/100BaseT)
Power port
Figure 3: Rear Panel
Standard parallel printer port. If you wish to share a printer, connect
it here.
This button has three (3) functions:
•
Reboot. When pressed and released, the LevelOne FBR-
1800TX Broadband Router will reboot (restart).
•
Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
•
Ensure the printer is ready.
•
Both Print LEDs will flash simultaneously during the diag-
nostic printing.
•
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The LevelOne FBR-1800TX Broad-
band Router is now using the factory default values.
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the LevelOne FBR-1800TX Broadband Router
will automatically function as an "Uplink" port when required. Just
connect any port to a normal port on the other hub, using a standard
LAN cable.
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Connect the supplied power adapter here.
Introduction
5