LevelOne WBR-1101TX User Manual page 55

LevelOne WBR-1101TX User Guide
If you see the following error message, either install Internet
Explorer 4 or later, or follow the procedure in the "Trouble
Shooting - Printing" section of Appendix A.
7. A pop-up message will inform you if the port has been created successfully, and then the
Windows Add Printer wizard will start.
•
Select the correct Printer Manufacturer and Model, or use the "Have Disk" option if
appropriate.
•
If desired, change the Printer name so it indicates the device used (e.g. HP2100 on
SCA43600)
•
If prompted about Sharing, do NOT enable Sharing.
8. Installation is now complete. You can now print using this printer.
•
To install additional Printers, repeat steps 6 and 7.
•
Use the Start menu to run this program in future. The default installation is Start -
Programs - Broadband Internet Router - Add Port.
Management
•
Print jobs can be managed like any Windows printer. Open the Printers folder (Start -
Settings - Printers) and double-click any printer to see the current print jobs.
•
If the printer attached to the LevelOne WBR-1101TX is changed, just run this program
again, and select the correct printer.
•
To delete a port created by this setup program, use the Windows Delete Port facility:
•
Right-click any printer in the Printers folder, and select Properties.
•
Locate the Delete Port button. This button is on the Details or Ports tab, depending
on your version or Windows.
•
If the LevelOne WBR-1101TX's IP Address is changed, and you can no longer print,
delete the port (see procedure above) and re-install it.
Port Options
The options for the Print Port Driver are accessed via the Windows Port Settings button.
Use Start - Settings - Printers to open the Printers folder, then right-click the Printer, and select
Properties. The Port Settings button is on the Details or Port tab, depending on your version
of Windows.
An example screen is shown below:
52