Table of Contents
Advertisement
LevelOne WBR-1101TX User Guide
Macintosh Clients
Internet Access
From your Macintosh, you can access the Internet via the LevelOne WBR-1101TX. The
procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field
can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the only change required is to
set the Router Address field to the LevelOne WBR-1101TX's IP Address.
Printing
If you wish to share the printer connected to the LevelOne WBR-1101TX, you must use a
LaserWriter or compatible printer.
Installing the Printer
To gain access to the printer connected to the LevelOne WBR-1101TX, follow this procedure:
1. Select Control Panel - Network.
2. Ensure that EtherTalk is selected under AppleTalk Connection.
3. Open Chooser, and select the correct printer type (e.g. LaserWriter 8).
4. From the list of available printers on the right, select the LevelOne WBR-1101TX, then
click Create.
5. The new printer will be created, and can be used like any other printer.
58
Advertisement
Table of Contents
