LevelOne WBR-1101TX User Manual page 59

LevelOne WBR-1101TX User Guide
Dial-in Configuration
This section describes how to configure your PC to use the LevelOne WBR-1101TX's RAS
Dial-in feature.
To use the RAS Dial-in feature of the LevelOne WBR-1101TX:
•
An Analog Modem or ISDN TA must be connected to the Serial Port on the LevelOne
WBR-1101TX.
•
The LevelOne WBR-1101TX's must be configured for Dial-in access, and Dial-in Users
must be created. See Chapter 6 - Dial-in (Serial Port) for details.
•
A suitable Dial-up connection must be created on your PC, as described below.
Creating a Dial-in Connection in Windows
You can use the standard Windows Dial-up Networking software normally used for Internet
access. The procedure is as follows:
1. Ensure your modem is installed and working.
2. Select My Computer, then Dial-up Networking.
3. Click Make new Connection, and step through the Wizard.
•
Give this connection a suitable name.
•
Enter the area code and telephone number to connect to the LevelOne WBR-1101TX.
•
Continue the Wizard until completed.
4. The default values for this connection will work with the LevelOne WBR-1101TX's
default values. If necessary, you can adjust the Properties for the connection:
•
In the Dial-up Networking window, select the connection.
•
Right-click, and select Properties to see a screen like the one below.
Figure 34: Dial-up Networking Properties
56