Dip Switches - LevelOne WBR-1101TX User Manual

Reset Button
PCMCIA slot
Power port

DIP Switches

DIP Switch Set-
ting
Restore Default IP Address and Clear Password
If the LevelOne WBR-1101TX's IP Address or password is lost, the following procedure can
be used to recover from this situation.
1. Turn the power to the LevelOne WBR-1101TX OFF.
2. Set DIP switch 1 ON.
3. Turn the power to the LevelOne WBR-1101TX ON.
This button has three (3) functions:
•
Reboot. When pressed and released, the LevelOne WBR-
1101TX will reboot (restart).
•
Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
•
Ensure the printer is ready.
•
Both Print LEDs will flash simultaneously during the diag-
nostic printing.
•
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values, as de-
scribed below.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The LevelOne WBR-1101TX is now
using the factory default values.
Insert the supplied Wireless PCMCIA card into this slot.
•
Ensure the power is OFF before inserting or removing the
PCMCIA Card.
•
Do not use any other PCMCIA Card.
Connect the supplied power adapter here.
Description
1=off Normal Operation.
2=off
1=off DHCP Server function disabled.
2=on
1=on Used to restore Default IP Address
2=off and clear Password (See below).
1=on Normal Operation.
2=on
Introduction
7