Static Routing Table - LevelOne WBR-1101TX User Manual

LevelOne WBR-1101TX User Guide
Data - Routing Screen
RIP
Enable RIP

Static Routing Table

Select Entry
Destination
IP Address
Network Mask
Gateway
IP Address
Interface
Metric
Buttons
Clear Form
Figure 41: Routing Screen
Check this to enable the RIP (Routing Information Protocol) feature of
the LevelOne WBR-1101TX.
The LevelOne WBR-1101TX supports RIP 1 only.
This drop-down list shows all entries in the Routing Table.
•
To view or change an entry, select it, then click the Get Data button.
•
After making any required changes, click the Update button to save
your changes.
The network address of the remote LAN segment.
For standard class "C" LANs, the network address is the first 3 fields of
this Destination IP Address. The 4
The Network Mask used on the remote LAN segment. For class "C"
networks, the standard Network Mask is 255.255.255.0
The IP Address of the Router on the LAN segment to which this device
is attached. (NOT the router on the remote LAN segment.)
Select the appropriate interface - LAN or WAN from the drop-down list.
Note: The "WAN" interface it only available if NAT (Network Address
Translation) has been disabled on the Options screen.
The number of routers which must be traversed to reach the remote LAN
segment. The default value is 1.
Clears all data, ready for input of a new entry.
th
(last) field can be left at 0.
76