LevelOne WBR-1101TX User Guide
Other Unix Systems
For Internet Access via the LevelOne WBR-1101TX
•
Ensure the "Gateway" field for your network card is set to the IP Address of the LevelOne
WBR-1101TX.
•
Ensure your DNS settings are correct.
LPD Printing
To use LPD printing to the LevelOne WBR-1101TX's printer, install an LPD printer using the
standard procedure for your system.
•
Use the LevelOne WBR-1101TX's IP Address as the location of the remote host
•
Use L1, L2, or L3 for the name of the printer on the remote host.
On the LevelOne WBR-1101TX, the logical printers (L1, L2, and L3) can be configured on
the Options - Printer Port screen.
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the LevelOne WBR-1101TX's
Access Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the LevelOne WBR-1101TX, each Wireless Station must
have compatible settings, as follows:
Mode
SSID (ESSID)
WEP
The mode must be set to Infrastructure.
This must match the value used on the LevelOne WBR-1101TX. The
default value is default
Note! The SSID is case sensitive.
By default, WEP on the LevelOne WBR-1101TX is disabled.
•
If WEP remains disabled on the LevelOne WBR-1101TX, all
stations must have WEP disabled.
•
If WEP is enabled on the LevelOne WBR-1101TX, each station
must use the same settings as the LevelOne WBR-1101TX.
60