Status Sub-Screens - LevelOne WBR-1101TX User Manual

Status Sub-Screens

This section describes the sub-screens which can accessed via links on the main Status screen.
WAN Status - Direct Connection
If the WAN (Ethernet) port is not using PPPoE or PPTP, then clicking the WAN Status link on
the Status screen will reveal a screen like the following.
Data
WAN Status
Physical Address
IP Address
Network Mask
Default Gateway
DHCP Client
Buttons
Restart Counters
Reconnect
Refresh
Figure 13: WAN Status - Direct Connection
The "Hardware" address of this device, as seen by other devices on the
WAN.
The IP Address of this device, as seen by devices on the WAN.
(This device has 2 IP Addresses; one for the local LAN, and another
for the WAN port.)
The Network Mask for the above IP Address.
IP address of the Router/Gateway on the WAN port.
Displays "Enabled" or "Disabled", indicating whether this device is
acting as a DHCP client on the Internet connection.
Set both Firewall counters back to zero (0).
Use this button if the connection seems to have been lost, and no data
is being transferred. (This button has no effect unless acting as a
DHCP Client.)
Update the data on screen.
Configuration
31