Table of Contents
Advertisement
LevelOne WBR-1101TX User Guide
Internet Access
WAN (Ethernet) Port
ISDN (Built-in ISDN TA)
Serial Port
Wireless
SSID
(Service Set Identifier)
•
Select this if using a Broadband modem (e.g. Cable or
DSL) connected to the WAN (Ethernet) port.
•
You must also select and configure the correct access
method:
•
Direct/Permanent Connection - Select this if your
have an "always on" connection, or your ISP did not
provide the login information (username, password).
•
PPPoE (PPP over Ethernet) - Select this ONLY if
your ISP uses PPPoE (PPP over Ethernet) and pro-
vides an Account/User name and Password.
•
PPTP (Peer-to Peer Tunneling Protocol) - Select
this only enable this checkbox if your ISP uses this
method of login, and has provided you with a "User-
name" and "Password", as well as the IP address of
the PPTP Server. Note that this does NOT provide a
VPN (Virtual Private Network) connection to another
LAN; it refers only to the login to the ISP.
•
You must click the "Configuration" button and
configure the sub-screen for the selected access
method!
See the following sections for details.
•
Select this if using the built-in ISDN TA.
•
The WAN/ISDN push-button on the rear of this
device must be set to "ISDN".
•
You must click the "Configuration" button and
configure the ISDN sub-screen!
See the "ISDN" section later in this chapter for de-
tails.
•
Select this if using an Analog Modem or ISDN TA
connected to the Serial (RS232) Port.
•
You must click the "Configuration" button and
configure the Serial Port sub-screen!
See the "Serial Port" section later in this chapter for
details.
To communicate, all Wireless stations MUST use the same
SSID/ESSID. You can either change this value, or change
your client Wireless stations, to ensure this.
The default SSID value for the LevelOne WBR-1101TX is
default.
Note! The SSID is case sensitive.
16
Advertisement
Table of Contents
