LevelOne WBR-1101TX User Manual page 67

LevelOne WBR-1101TX User Guide
Modem Proper-
ties
Serial Line
Speed
Dial-In
Enable Dial-in
Disconnect after
Idle Time
Dial-in
PPP Link
Dial-In Users
Dial-in Users
Link
•
If your modem is in the drop-down list, just select it.
•
If your modem is not in the list, select "_Standard Modem" and
test to see if this works.
•
If "_Standard Modem" does not work, select "Other", then click
the Modem Properties button and set these settings correctly. See
the section Modem Properties Screen later in this chapter for fur-
ther details.
Clicking this button will open the Modem Properties screen and allow
changing of the modem's properties. Normally, this is not required.
See the section Modem Properties Screen later in this chapter for
further details.
Select the speed which is equal to or below the fastest Serial line speed
(NOT Phone line speed) of your modem. Available speeds range from
4.8K to 460.8K (bps).
If checked, this port is available for dial-in access. Otherwise, any
attempt to dial-in will be blocked.
If Internet Access is also enabled, Dial-in users may find it difficult to
connect because the telephone line is in use. Reducing the Disconnect
after Idle Time setting for Internet Access to 1 minute may help.
•
See Dial -in Users later in this Chapter for details of creating and
managing dial-in users.
•
See the Dial-in section in Chapter 4 - PC Configuration for details
on setting up the remote PC to use the LevelOne WBR-1101TX's
Dial-in facility.
If checked, a Dial-in connection will be terminated after the specified
time-out period. The allowable range is 1-99 minutes.
If preferred, the connection time limit may be set individually for each
user.
Select the desired security option for log-in:
•
PAP has widespread support; almost all communications systems
support it.
•
CHAP is more secure than PAP; the password is encrypted before
transmission. If it is selected, the dial-in clients must also support
CHAP in order to connect.
•
MS CHAP is the Microsoft version of CHAP, used on Windows
platforms. If all dial-in clients are using Windows 95 or later, you
can choose this option.
•
None means no login authentication is performed.
Warning! If you choose "None", anyone can connect; this is a major
security risk.
Use this link to create and manage users for the RAS Dial-in function.
See the Dial-in Users section later in this chapter for details.
64