Check The Leds - LevelOne WBR-1101TX User Manual

LevelOne WBR-1101TX User Guide
2. Insert Wireless PCMCIA card
Ensuring the supplied Wireless PCMCIA card is the right way up, insert it into the slot on
the rear. Push it firmly until it clicks into position.
3. Set the ISDN/WAN Push Button
The ISDN/WAN push button is on the rear panel. Ensure it is set correctly:
Depressed (in) - ISDN port is active.
Extended (out) - WAN port is active.
4. Connect WAN cable OR ISDN cable
•
If you have a Broadband modem, connect it to the WAN port on the LevelOne WBR-
1101TX. Use the cable supplied with your broadband modem. If no cable was supplied,
use a standard LAN cable.
•
If using an ISDN connection, connect the ISDN port on the LevelOne WBR-1101TX to
the S/T connector on your ISDN NT1 (Network Terminator 1).
5. Connect LAN Cable
Connect a standard LAN cable from a 10BaseT or 100BaseT Hub on your LAN to the
"HUB" port on the LevelOne WBR-1101TX.
6. Connect Serial Port Modem (optional)
If you wish to use an Analog modem or external ISDN TA, use a standard serial cable to
connect it to the Serial port on the LevelOne WBR-1101TX.
7. Connect Printer Cable
Use a standard parallel printer cable to connect your printer to the Printer port on the Leve-
lOne WBR-1101TX.
8. Power Up
Connect the supplied power adapter and power up.
Use only the power adapter provided.

9. Check the LEDs

•
The Power LED should be ON.
•
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
•
One (1) of the LAN LEDs (10 or 100) should be ON.
•
The Wireless LED should be ON.
•
If the printer is On and On-line, the Print Act LED should be ON.
•
If using the WAN port, the WAN LED should be ON. (If it is not, check that the Broad-
band modem is connected and ON.)
If using the ISDN port, the ISDN LED should be OFF. It will not come On until a connec-
tion to your ISP is established.
For more information, refer to Front-mounted LEDs in Chapter 1.
The WAN port and ISDN ports can NOT be used simulta-
neously. The ISDN/WAN push button on the rear panel
determines which port is active.
10