Motor Replacement (Remote Control Model) - Magiglo TRIBUTE PD-08-002 User, Installation & Servicing Instructions

4.2.5.

Motor Replacement (Remote Control Model)

The gas rate adjusting motor is replaceable
in situ.
1. Remove the batteries from the receiver
unit to prevent the risk of short circuit.
2. Remove the two motor connection tags
from the valve.
3. Remove the valve cover securing screw.
4. Unclip the valve cover from the valve on
the right hand side by inserting a very
small screwdriver in the slot on the right
hand front of the cover and pull out the
cover.
5. Turn the gas rate adjusting knob fully
anticlockwise and gently manipulate the
motor free from the valve (see note).
6. Replace with new motor ensuring that
the motor is hooked into the right hand
lug.
7. Replace the cover and secure with the
screw.
8. Remake the motor connections ensuring
that the large tag is fitted to the large
spade (top connection) and vice versa.
9. Replace the batteries ensuring the
correct polarity.
10. Operate the handset to check the
operation of the motor.
Note: Operating the gas rate adjusting knob manually will cause the motor clutch
to operate. This is normal and will not affect the valves' operation.
Page 38
Valve Cover
HT
Securing
Lead
Screw
Figure 43
Figure 44
Drive
Motor
Gas Rate Adjusting
Knob
Figure 45