Magiglo TRIBUTE PD-08-002 User, Installation & Servicing Instructions page 24

Back Panel/
Surround
Lintel
200mm
min
Base
Figure 25
11. Important! The Fire cement supplied
must be applied around each of the duct
spigots on the rear of the appliance to
guarantee a seal. Do not use silicone
based sealants anywhere around the
firebox.
12. Push the two lengths of ducts previously
cut on to the duct spigots. Make sure the
ducts are pushed fully home up to the
firebox.
13. Position the firebox complete with ducts
attached centrally into the fire opening.
Thread the cables through the eye-
screws. With the firebox placed close to
the fireplace opening feed the two cables
through the matching eye screws (left
cable through left hand set of eyelets
and the same for right hand cable) and
then back into the holes at the bottom
rear of the firebox (see
Figure 26). Remove the grommet from
the gas inlet slot on the firebox to allow
for gas pipe to come through. Whilst
pulling the cables, push the firebox
gently into the opening (ensuring that
the gas pipe emerges from the rear slot)
until the flange of the firebox abuts the
fire surround (or the wall).
Feed each bare cable end into the hole
in the brackets on the base of the firebox
and in turn through the hole at the
threaded end of the cable tensioning
screw. (See
Page 20
L
Terminal/
Air Duct
Figure 27).
Back Panel/
Surround
eye-screw
Cable
eye-screw
Base
Figure 26
Cable Tensioning
Screw
Cable
Thumb screw
Figure 27
Terminal/
Air Duct
Wall
Plate
Wing Nut