Table of Contents
Advertisement
2.2.3.
Lighting Procedure (Total Control)
1. Ensure that gas is available at the valve
and the ON/OFF switch in the ON
position (–). (See Figure 9)
2. Simultaneously press and hold the
(red
circle)
buttons until a short acoustic signal
confirms the start sequence has begun,
then release the buttons (see Figure
10).
3. The pilot flame should stay alight. If the
flame goes out repeat the procedure
above to establish the pilot. Due to
safety and the efficient way the fire
works, it is not unusual for the pilot to
stay alight only after the second or even
third attempt.
4. Continuing signals confirm the ignition is
in process. Once the pilot is lit the gas
rate
adjusting
turns to high gas rate.
burner cross-lights from the pilot.
5. To adjust the gas rate to desired setting
press the
(large flame) to increase the
flame height or
decrease the flame height on the
handset (see Figure 10).
6. For fine adjustment tap the
buttons.
7. To leave the burner in the standby
mode press the
main burner goes out. In the standby
mode the pilot stays alight.
and
(large
flame)
knob
automatically
The main
(small flame) to
or
(small flame) until the
8. To turn off the main burner and the pilot
press the 'OFF' button on the hand set.
Figure 9
Figure 10
Page 7
Hide quick links:
Advertisement
Table of Contents
